Thingiverse
M4 Pmag Wall Holder
door XDr4g0nX
253
Downloads
178
Likes
1
Makes
The second half of a customers commission was for me to make a wall mount for M4 Pmags.
So after some measuring of 2 different Pmags I found a good measurement that I think fits most Pmags.
The holes are designed for 3.5/4mm countersunk screws.
Also check out the [M4 Pmag wall holder - extension](https://www.thingiverse.com/thing:3598700) I made so you can store magazines on top of each other.
-----
Don't have a printer yourself? Buy it from me in my Etsy shop here:
https://www.etsy.com/listing/739067750/m4-pmag-wall-holder
So after some measuring of 2 different Pmags I found a good measurement that I think fits most Pmags.
The holes are designed for 3.5/4mm countersunk screws.
Also check out the [M4 Pmag wall holder - extension](https://www.thingiverse.com/thing:3598700) I made so you can store magazines on top of each other.
-----
Don't have a printer yourself? Buy it from me in my Etsy shop here:
https://www.etsy.com/listing/739067750/m4-pmag-wall-holder
XDr4g0nX publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
