Thingiverse
M5 Washer
von MarkFortune
9
Downloads
8
Likes
0
Makes
I needed a washer for an M5 screw, so I made one! Nothing fancy.
OD: 9mm
ID: 5mm
Height: 2mm
It should fit under the head of any M5 screw. It's a little tight so you need to thread it on a little to start.
Lay it flat while printing
OD: 9mm
ID: 5mm
Height: 2mm
It should fit under the head of any M5 screw. It's a little tight so you need to thread it on a little to start.
Lay it flat while printing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
