Thingiverse
M5StickC PLUS 2 Case
von kuzmichov
2
Downloads
11
Likes
1
Makes
A very convenient case for using the M5StickC PLUS 2
You can print without supports, just remove the built-in supports. I recommend 100% filling, low print speed and a layer height of 0.1
You can print without supports, just remove the built-in supports. I recommend 100% filling, low print speed and a layer height of 0.1
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
