Slicer Discord
M6A2E1 Heavy Tank – 3D-printbaar model van Thingiverse Thingiverse

M6A2E1 Heavy Tank

door Engineer13
130 Downloads
73 Likes
3 Makes
Model downloaden
Merry Christmas, a small gift to go along with my collection of M6 Variants.

I think this variant of M6 deserves its own post.

In 1944, the Americans were pondering what to do about some of the later (and heavier) German panzers. They thought of putting a 105mm anti-tank gun on a vehicle, but they lacked a vehicle that could carry it...except an old M6 prototype. They replaced the turret on 2 of the prototypes with an new M6A2E1 turret. The tank was tested, and the gun was found to be good, but needed a new type of tank. This lead to the development of T29 and that series of tanks.


Update 3/31/19
-Hull updated (like other M6 variants)

Update 4/3/19
-Turret Size increased (Plug did not fit and turret seemed a bit off when I printed it.)

Update 4/3/20
-Edited the 105mm gun muzzle break

For M6, M6A1 and M6A2 -> https://www.thingiverse.com/thing:3174913
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie