M8 Easy Adjust Clamp

(sorry for the short explanation... )

This clamp is simmilar than my M16 clamp. However instead of the nut on the rear clamp it uses a M10 Washer to pinch the threaded rod. This is for easy size adjustment. So, to do a major size (open and close) adjustment unclip the front part and swing it down about 30deg this will allow the washer to slide freely. Once its the size you want clip the part onto the rod again and tighten the clamp using the screw at the end.

The hole in the one part is to insert a nylon nut onto the rod so it doesnt slide all over.