Thingiverse
M8 washer 3cm
di DarkoDDio
29
Download
13
Likes
1
Makes
There is also a little spacer near the hole
Version 2: After printing I noticed that the 8mm whole was too tight
So I increased it by .1 mm in V2
I've also noticed that must be printed without raft to have a better bottom layer
Version 2: After printing I noticed that the 8mm whole was too tight
So I increased it by .1 mm in V2
I've also noticed that must be printed without raft to have a better bottom layer
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
