Thingiverse
M8Q-5338 holder
door macourteau
4
Downloads
8
Likes
0
Makes
Holder for the Matek M8Q-5883 GPS/compass chip. There is a 12mm wide gap at the bottom to feed the battery strap through, or some zip ties.
The holder was designed to hold the cable in position inside the holder to make it nearly impossible for the cable to unplug during flight. There's also holes that make it possible to see the LEDs.
It's a very tight fit, but it should hold the chip in place and protect it during flight :)
The holder was designed to hold the cable in position inside the holder to make it nearly impossible for the cable to unplug during flight. There's also holes that make it possible to see the LEDs.
It's a very tight fit, but it should hold the chip in place and protect it during flight :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!