Thingiverse
M9 Gimbal protector
48
Downloads
33
Likes
0
Makes
Gimbal protector for Taranis M9 gimbals.
M9 gimbal stick "is" 8mm. Hole in protector is 8.6mm.
On most common printers:
PLA loose fit
PETG tight fit
ABS use 8.5mm drill to enlarge hole
Use a rubber/silicone gasket like the ones for vibration dampening your flight controller to make it a tight fit (See picture)
M9 gimbal stick "is" 8mm. Hole in protector is 8.6mm.
On most common printers:
PLA loose fit
PETG tight fit
ABS use 8.5mm drill to enlarge hole
Use a rubber/silicone gasket like the ones for vibration dampening your flight controller to make it a tight fit (See picture)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
