Mac Keyboard Stand - Remixed

I look the original design which was good, but it lacked a good way to attach to the keyboard short of double sided tape/glue to make it kind of permanent.

I like magnets and really, who doesn't?

So I took the original design and sunk a 1.5mm x 10mm hole into the middle (tilted to correct angle).

I then used these magnets:

North Showing - https://www.amazon.co.uk/gp/product/B00TACFTAA
South Showing - https://www.amazon.co.uk/gp/product/B00TACFTEG

Ignore the notch I cut in one of the photos that was an attempt to see if accessing the switch would be easier. It's not really.

The way I attached the magnets is as follows:

1. Into each foot place 1 small drop of CA glue (very small), then removing the backing from the magnets (ex the North showing one), push one into the hole with the glue on both feet.

2. Let these set and dry completely.

3. Drop the south showing magnet on top of each north showing one, then remove the paper backing from both

4. Simply lin