Macberry Plus

There are better scaled down models of the Macintosh Plus to put a Raspberry Pi in and emulate a vintage Mac, but they all require 3:4 screens. I wanted to design a Raspberry Pi case inspired by the Mac Plus but using current hardware and that meant a 16:9 aspect ratio screen.

Additionally, I didn't want to wait 2 days for the large case to print since it was only going to be filled with air. So I foreshortened it. I'll post the full case at some point as an alternative.

These parts will fit on a 300 x 300 bed when turned appropriately. I used organic supports because they're easy to remove. Everything printed from a single 1KG spool of PLA except for the USB bracket, which I printed with black.

If this also meets your requirements, enjoy.

Parts:
- Raspberry Pi 4 (4GB) running Mini VMac :)
- 8" Waveshare 1280x800 16:9 IPS display https://a.co/d/5Ibor8A
- PHEVOS 5v 5a PSU https://a.co/d/0PNhDHB
- Rocker switch power socket https://a.co/d/5MKkO6b
- USB C pigtail https:/