Macbook USB-C cable holder

Tired of USB-C cables getting disconnected, I created this holder. No more issues now :)

Laptop: MacBook Pro (13-inch, 2017, Two Thunderbolt 3 ports)

I imagine that cables are pretty standard but double check if the body of the connector it's kinda the same size.

This model it's for a 22mm plug body.

Gcode it's for Artillery Sidewinder X1 as the Cura project.

I suggest using the brim, just to have a good adhesion, but it's up to you + your printer.

I was also using 10% infill cause without, while removing the supports, the box normally breaks.


Update: V2 uploaded with a bigger holder. V1 broke after some uses, so I just made it bigger
DO NOT CLOSE THE LID WITH THIS ON. COULD BREAK YOUR SCREEN.