Thingiverse
Mace v1
por affini3
125
Descargas
233
Likes
2
Makes
Edit 22/9 I noticed that this became popular again in the searches so designed a spiked mace on my patreon, it's on there for free and will come on here in a few months, also going to remake this one too as I've got better at designing.
take two of uploading this, think my internet is dying
so i made this this week, 4 days from design to finished, anything to avoid from sanding, i hate sanding so much.
Like all my other prints it has a 13mm channel through the middle to allow you to put a 12mm wooden dowel through the core so that it has decent strength so you can flail about as much as you want.
Total length is about 55cm (EndCap - Head - Spacer - 2x Shaft - Spacer - 3x Grip - EndCap)
I've also included the head split into two pieces so that you don't have to do 1 massive long print, I wasn't bothed about finish on this so just painted it after printing so did it at 0.3mm layer height and the head was over 4 hours.
If you want any variations all additional pieces l
take two of uploading this, think my internet is dying
so i made this this week, 4 days from design to finished, anything to avoid from sanding, i hate sanding so much.
Like all my other prints it has a 13mm channel through the middle to allow you to put a 12mm wooden dowel through the core so that it has decent strength so you can flail about as much as you want.
Total length is about 55cm (EndCap - Head - Spacer - 2x Shaft - Spacer - 3x Grip - EndCap)
I've also included the head split into two pieces so that you don't have to do 1 massive long print, I wasn't bothed about finish on this so just painted it after printing so did it at 0.3mm layer height and the head was over 4 hours.
If you want any variations all additional pieces l
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
