Machine Vise with M5 Mount Nuts

###This is a remix of [Yet ANOTHER Machine Vise by TheGoofy](https://www.thingiverse.com/thing:2064269), to be used as base for [LiftPod](https://www.thingiverse.com/thing:4614448).

###Modifications:
- 3 slots for M5 nuts on one end. Allows to screw in 3 M5 bolts.
- Printed thread changed to 45 degree overhang, easier to print, and longer pitch.
- 6.35 Hex hole at the end of knob to drive easily.
- Tolerance generally increased from 0.15mm to 0.25mm.
- Added a 0.6mm flexible sleeve to increase friction.

###It takes M5x25(or 20) bolt for LiftPod. Same as the clamp bolt.
###Print the sleeves with flexible material.
###No supports required. 0.2mm layer height. 3 wall lines. 35% infill. Increase top/bottom thickness to bases if you require more strength.
###The M5 knob might appears to be ultra large in some slicers because the unit is falsely recognised as cm. If that's the case, just scale down to 10% in slicer.
###Visit the page of original design for assembly instr