MadCase ND Filter
door naZty_niZmo
4
Downloads
2
Likes
0
Makes
A custom front soft plate for the Madcase to fit TBS ND Filters.
Model ND8:
Fits TBS ND Filters 2, 4 and 8
Model ND16:
Fits TBS ND Filters 16 and 32 - (fits ND8 sizes with some extra space since ND8 and lower are thinner)
There are also a few tweaks to the original model. I added a beveled edge on the inside to rest nicely on the Sessions beveled edge. I added stoppers in the stud holes to stop the corners from flexing in. I also extended the legs to touch the bottom lock without a gap.
Blend file is included.
***NOTE:*** You will see the carbon fibers round corners while in Superview or Wide mode. You may be able to file down the rounded edges on the front plate, but I haven't tried it yet. If you use ReelSteady Go, it may not matter since it will get cropped out.
Model ND8:
Fits TBS ND Filters 2, 4 and 8
Model ND16:
Fits TBS ND Filters 16 and 32 - (fits ND8 sizes with some extra space since ND8 and lower are thinner)
There are also a few tweaks to the original model. I added a beveled edge on the inside to rest nicely on the Sessions beveled edge. I added stoppers in the stud holes to stop the corners from flexing in. I also extended the legs to touch the bottom lock without a gap.
Blend file is included.
***NOTE:*** You will see the carbon fibers round corners while in Superview or Wide mode. You may be able to file down the rounded edges on the front plate, but I haven't tried it yet. If you use ReelSteady Go, it may not matter since it will get cropped out.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
