Madcase Slide (ImpulseRC Alien)
por naZty_niZmo
1
Descargas
0
Likes
0
Makes
Have a Madcase on your Session and fly an Alien? Perfect!
The Madcase Slide was designed to easily remove the GoPro to swap quad to quad. Even change your GoPros angle without changing the base. The Madcase Slide has 11 angled insets ranging from 0 to 50 degrees, at 5 degree increments.
Use a M3x30mm (min) bolt to secure the Slide. The M3 nut should sink in when tightened and stay put.
There are 2 optional M2 holes on the bottom of the Base. If your base is curving up, you can screw a couple M2x6mm screws through the top plate, into the bottom of the Base.
Also have an ImpulseRC Apex? Just print the [Apex Base](https://www.thingiverse.com/thing:3932597) and use the same Slides!
UPDATE: Fixed the topology of the base model.
The Madcase Slide was designed to easily remove the GoPro to swap quad to quad. Even change your GoPros angle without changing the base. The Madcase Slide has 11 angled insets ranging from 0 to 50 degrees, at 5 degree increments.
Use a M3x30mm (min) bolt to secure the Slide. The M3 nut should sink in when tightened and stay put.
There are 2 optional M2 holes on the bottom of the Base. If your base is curving up, you can screw a couple M2x6mm screws through the top plate, into the bottom of the Base.
Also have an ImpulseRC Apex? Just print the [Apex Base](https://www.thingiverse.com/thing:3932597) and use the same Slides!
UPDATE: Fixed the topology of the base model.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
