Mag Holster

*** I'm adding a newer version of my design that's stronger and for a 1.75" belt. Check my profile for the updated one.

This is my first design and I've only been 3d printing for a few weeks.

[Sig P320] files and [Baarretta M9/Walther PPQ] mag holders

(The baretta and Walther mags are almost identical)


These holders accept three of these magnets for the retention:
https://www.homedepot.com/p/Master-Magnet-3-4-in-Neodymium-Rare-Earth-Magnet-Discs-3-per-Pack-07091HD/202526387

i like to superglue the magnets in, obviously if they were to come out with the mag it would be very bad. For this reason the tolerance is very tight so you may have to sand the magnets down slightly to fit into their pockets before super glue.

When done you will have to file and or sand the inside of the holster to get your desired retention. For me personally I took mine down to the point that the only thing holds the mag is the magnets. Super faster and comp friendly!

PS there is a hole i