MagHex Holder

MagHex Holder
----------------------
All my MagHex prints were getting messy, so I made this to keep it organized.

###Features
* Holds all your MagHex Tiles and tops together and keeps them organized
* Each stack holds 50 MagHex tiles, or ~150 tile tops
* Uses just a few rubber bands to hold everything together. (no magnets, sadly)

###Notes
* Stacks print in vase mode ("Spiralize Outer Contour" in Cura). Set "bottom thickness" to 2mm to print the base solid.
* Takes a minimum amount of filament and time. About 70g for each Endcap and 240 for the Case.

###Changelog
03.19.2020
* Huge redesign of this thing.
* Made the Endcaps deeper to hold the stacks better
* Made the Case optional in the design to save filament

06.03.2019
* First upload of the design.