Magic 8 ball with battery

Remake of my plug-in magic 8 ball.

You will need some basic Arduino and soldering skills for this. You can get the info you need for the Arduino skills at www.Arduino.cc

With a little bit of practice and training you can easily change all of the responses.

Setting up electronics on a breadboard print to printing is a good idea.

Wiring setup:
Battery holder:
Positive to B+ on Charger Board
Negative to B- on Charger Board

Charger Board:
Out+ to PIN 30 (VIN) on Nano 33
Out- to PIN 29 (GND) on Nano 33

Nano 33:
PN 4 (GND) to GND on OLED
PIN 17 (3.3v) to VCC on OLED
PIN 23 to SDA on OLED
PIN 24 to SCL on OLED


PART LIST:

Jumper wires and/or soldering setup.

Battery holder
https://www.amazon.com/dp/B00LSG5BKO/ref=cm_sw_em_r_mt_dp_66Q4CJF6CMS4ZG26CWQS?_encoding=UTF8&psc=1

Charger board
https://www.amazon.com/dp/B00LTQU2RK/ref=cm_sw_em_r_mt_dp_SNPDM7BEHPXMW4NR1PA1?_encoding=UTF8&psc=1

Nano
https://www.amazon.com/dp/B07WV59YTZ/ref=cm_sw_em_r_mt_