Thingiverse
Magic Band + Stand Version 2
by imateo44
3
Downloads
16
Likes
0
Makes
Decided to try and make a charging station for Disney Magic Band+. Will accept 4 magic band chargers, with enough room to charge 4 bands at the same time, with the use of a USB hub.
This is my second try at this print. I was able to make the openings just a little tighter (you will need to press the chargers into the slots), also added the insets for the area around the charger itself. After printing, I noticed that I needed openings for my USB hub that I had, so I redid the print with these openings. It will still fit a usb hub inside the "tube" if you decide to go that route.
This is my second try at this print. I was able to make the openings just a little tighter (you will need to press the chargers into the slots), also added the insets for the area around the charger itself. After printing, I noticed that I needed openings for my USB hub that I had, so I redid the print with these openings. It will still fit a usb hub inside the "tube" if you decide to go that route.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
