Magic Mouse upgrade case

couldn't fine anything alike, and nothing stable, so I made my own variations. mouse slides in from the front. I recommended PLA print with structural supports auto on orca slicer. clean look for the mouse and had couple of designs. mark 2 is my favourite as its the most portable and comfort. all 3 cases may wobble as there is no under support, this is because of clearance and the mouse being 0 to the surface and no sacrifice made in the design. to balance the sides and rear on the mark4 you may need extra padding, free hand. 🖐️


print with 3 wall setting and 0.6, much faster, for quality go with 0.18 layer height. supports must. print as is advised.

mark 6 is very comfortable and I have large hands. mark 5 is trash and it makes it more uncomfortable so I took it down.
mark 7 latest after intensive testing and modelling.