Magic Tripod Levitation Stand

Print it yourself or [order from Shapeways](https://www.shapeways.com/product/TMKC6HUU5)!

Three legged levitation stand. Derived from the four legged stand in thingiverse.com/thing:4070060. Unlike the four legged version, this one does not have a way to wobble in any direction if any lines are not slack. Also, the holes for the lines are arranged so one continuos line can be used for all of the outer lines.

Setup instructions:

Print both parts, then use the diagram to thread through the lines: First add the inner short line (green), then attach the outer line (red) on one end, and thread through to the other end. Pull taut, and tie off at the other end. I found that using a needle to thread through the line worked quite well. If you find that the line is sliding too easily and the top is toppling over, fix it to the frame with some tape, superglue, or wedge it in two of the through-holes.