Thingiverse
Magic Wand
by kamondelious
5
Downloads
9
Likes
0
Makes
A simple classic style magic wand.
The pieces are meant to be printed standing on end, so make sure you have good bed adhesion. Supports are needed on the connector piece.
As pictured, I used 2x WandTips, 2x WandShafts and 3x WandConnectors. I have played at attaching more shafts together, for more of a walking stick type look and it seems to hold up well.
I have printed a few of these for my kids to play with and they have been enjoying them.
I recommend a higher infill setting for the WandConnector pieces. 15% works, but will not hold up well to children.
The pieces are meant to be printed standing on end, so make sure you have good bed adhesion. Supports are needed on the connector piece.
As pictured, I used 2x WandTips, 2x WandShafts and 3x WandConnectors. I have played at attaching more shafts together, for more of a walking stick type look and it seems to hold up well.
I have printed a few of these for my kids to play with and they have been enjoying them.
I recommend a higher infill setting for the WandConnector pieces. 15% works, but will not hold up well to children.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
