Magicforce Case

If you'd like a similar case that's 3D printed except for the screws, check out [this design](https://www.thingiverse.com/thing:3019052).

This is a case for using up leftover MF68 PCBs, as designed by di0ib. Since the minimum order from JLCPCB is 5x, you're going to have some leftover parts if all you wanted was to swap the PCB on an existing Magicforce. Basically, you could use this to build new keyboards with that layout from scratch.

##### Additional parts (beyond the MF68 BOM):

- 6x McMaster # 94459A150 M4 threaded inserts, heat set, brass (buy extra, these are easy to mess up)
- 6x McMaster # 92832A326 M4 x 8mm button head screws, torx, ZP (or similar)
- 6x McMaster # 95495K39 Rubber feet (or similar)

##### Configuration:

Tilt is customizable, and the STLs are configured with 1 degree positive tilt (towards you). Set "Hand" to either L or R to set which half OpenSCAD gives you.

##### Pre-processing:

You'll need to calibrate for expected shrink/scaling err