Thingiverse
Maglite wall holder
142
Downloads
90
Likes
1
Makes
A wall holder for a 6 cell D battery ML300l maglite flashlight. This is the heaviest maglite so the holder should work for all of the big sized ones.
Printed at 0.2 on an ender 3 with 30% cubic infill using cura. Very strong. seems like it will tear out of the wall before the plastic breaks (i tried).
Only hardware required is screws. I believe the head size was 9mm and the screw hole was 5mm
Printed at 0.2 on an ender 3 with 30% cubic infill using cura. Very strong. seems like it will tear out of the wall before the plastic breaks (i tried).
Only hardware required is screws. I believe the head size was 9mm and the screw hole was 5mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!