Thingiverse
Magnet Pocket Guide
von Resident36
0
Downloads
0
Likes
0
Makes
Simple guides for using endmills in a drill to create recessed pockets for round magnets.
2mm to 12mm. 2mm, 3mm, 4mm, 5mm have 2 sizes. 1 with a 4mm shank, the other with a 6mm shank. Recommend printing one of the 2 shank sizes in a separate color for quickly identifying shank diameter. The holes on the side allow for more light in while centering it.
For use with cheap metric endmill sets as found on Amazon, eBay, etc.
5th of June 2026:
Added a box with a removable lid to hold the guides. Also added in angled insert to assist in removing the 1,2,3mm spacers.
2mm to 12mm. 2mm, 3mm, 4mm, 5mm have 2 sizes. 1 with a 4mm shank, the other with a 6mm shank. Recommend printing one of the 2 shank sizes in a separate color for quickly identifying shank diameter. The holes on the side allow for more light in while centering it.
For use with cheap metric endmill sets as found on Amazon, eBay, etc.
5th of June 2026:
Added a box with a removable lid to hold the guides. Also added in angled insert to assist in removing the 1,2,3mm spacers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!