Magnetic Bit Driver Handle

Over the years I have collected a lot of bits in different forms and sizes. But without a bit driver they are pretty much useless. Therefore I have designed this Magnetic Bit Driver Handle. Features:Can be used with every 1/4'' (6.35mm) standard bitBits are hold in place by a Ø4x2mm magnetThe clip-on endcap rotates for easy operationTwo small standard bits can be stored in the handlePrintable in multicolour or single colour (so, AMS is optional)Only needs 23gr filamentPrint preparation:Make sure that your print bed is clean and grease-free and use a quality brand and dry filament. If you are having bed adhesion issues you can always try the new Bambu SuperTack plate (do not forget to change the plate in slicer). Print settings:Use the 0.2mm standard settings for everything. Support should not be needed, but you can add tree support for the magnet position in the handle. All my test prints were ok without support, so my profile is without support. A brim for the handle is recomm