Magnetic Bits Holder

I used 5 magnets, 20x10x3 (nominal size). I bought them on AliExpress [here](https://aliexpress.ru/item/1005003108988599.html). But it's not a rare staff, you know.

Ok, here is the point: 5 magnets on single metal strip, locked in the printed holder. The holder ribs are required for prevent the bits flipping.

For grouping the magnets I used a metal strip of 0.3mm thickness. You can make this thing without the common strip, but I think it can be a bit awkward. And probably you'll need to configure the thing for the less thickness of the magnets. How to configure, see below.

I glued the holder to the adhesive tape, but there is also an option to screw it on.

#### Printing disclaimer

You must have a well calibrated printer including correct flow setting for the filament which you suppose to use. The printing tolerance - **0.15mm**.

If you're not sure or didn't understand what I'm talking about - don't waste the time to make this thing. Or don't blame me after all that _your_ printed