Magnetic Broken Heart

Print Settings & Technical DetailsTechnology: FDM (Fused Deposition Modeling)Material: PLA (Recommended for rigidity and ease of printing).Layer Height: 0.20mm (Standard) or 0.16mm (For smoother top lettering).Infill: 15% to 20% (Gyroid or Grid pattern).Supports: No supports required (Printed flat on the bed).Walls/Perimeters: 2 or 3 walls.Color Technique: Filament Change (Pause at Height). Set a pause in your slicer software at the specific layer where the text begins to swap the filament color (e.g., changing from Red base to White text).Assembly & Finishing InstructionsTo ensure the perfect magnetic "click" and proper fit, follow these steps:Preparation: Remove the print from the bed and clean up any stringing if necessary.Magnets: This design fits 5mm x 1mm round neodymium magnets.Gluing:Apply a tiny drop of CA glue (Super glue/Cyanoacrylate) into the magnet slot.CRITICAL STEP: Before gluing the magnet into the second half, check the polarity. The magnets must attract each