Magnetic Cable Clip

This is a cable clip that has a hollow base in order to fit a 6 mm diameter x 3 mm height magnet. I made the magnet completely covered on both sides so that the magnet can't slip out while using it. It takes a little force to open it enough for the cable to fit for the first time but after that it works well. I personally use these to clip my dangling cables to a metal piece on my desk and a sticky magnet in my car. It isn't the strongest just because the magnet is quite small but it gets the job done.

Printing: Print on the flat face of the round magnet. All you have to do while printing is pause the print right before the hollow space is going to be filled (I used Bambu Studio and I added a pause at layer 17) so that you can place the magnet inside and then continue the print. I would also recommend to use Tree supports (auto) and select the option "On Build Plate Only" so that the software doesn't put a support in the empty space that is needed for the magnet.

These are the magnet