Magnetic Cable Clips

Magnetic Cable ties I made to organize cables for my printers and other electronics. Magnet holes are for 6x2mm neodymium magnets for people in the UK they can be found here, each tie requires 4 magnetsPrint in PETG if planning to make use of the countersunk screw holes (for 3.5mm woodscrews)If planning to use adhesive tape PLA should be fine Make sure when gluing magnets into the slots that correct polarity is maintainedSimple picture guide below Start by putting a small amount of superglue into the magnet holes of the bottom piece (I recommend mitre glue used in woodworking or superglue with activator for speed of assembly) try not to apply too much as it will overspill in next step and cause problems. Next place 2 magnets stacked on top of each other into each hole as shown below Once glue has set place glue the holes in the top piece Place the bottom piece onto the top aligning the magnets into the holes