Magnetic Catch

I printed this magnetic catch because the plastic parts on my window covers started breaking apart.The measurements of this part are 50x15x5mm and it fits a 30x10x2mm flat magnet very snugly. It may be needed to widen the gap with a small knife, however I didn't need to make any adjustments after printing.The screwholes fit a 7mm head and are a tight fit for a 3mm plastic/wooden screw.The distance between the two holes ist approximately 40mm. Print settings:0.2mm layer height20% infill is more than enoughprint without rafts or supportsPLA is most likely strong enough, as the part it's replacing doesn't see much stress