Slicer Discord
Magnetic Chess Set – 3D-Druckmodell von Thingiverse Thingiverse

Magnetic Chess Set

195 Downloads
155 Likes
0 Makes
Zum Modell
This is a magnetic chess set I designed. [Quick video of it in action here](https://imgur.com/a/dFsRSt0).

I made it so each 2x2 set of squares are fixed together permanently with glue. I used hot glue, but you could easily epoxy it.

Each side of the 2x2 set has 2 pockets for magnets, and each square has a pocket in the middle. Each piece has a pocket built in as well.

You will need to PAUSE the print to insert the magnets in most of these, as they are embedded. Unless you are unusually quick and / or dexterous. I used super glue for the magnets so they don't get picked up by the hot end.

The magnets I used were 6mm in diameter by 2mm in thickness. Make sure to be careful of your magnet polarity. It's easy to get them reversed - see the graphic.

Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen