Thingiverse
Magnetic dentalcase
von Mettich
1
Downloads
2
Likes
0
Makes
This is a dentalcase I designed as a little task for myself.
The design uses 6 2mm*1mm magnets to hold the case together. I designed it with tolerances in mind so it would work on a P1P.
The magnets are pressfit but can also be glued in for extra support.
Its a fairly easy print with no special settings required.
The design uses 6 2mm*1mm magnets to hold the case together. I designed it with tolerances in mind so it would work on a P1P.
The magnets are pressfit but can also be glued in for extra support.
Its a fairly easy print with no special settings required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
