Slicer Discord
Magnetic Door Handle – 3D-Druckmodell von Thingiverse Thingiverse

Magnetic Door Handle

von Dorithos
2 Downloads
4 Likes
0 Makes
Zum Modell
I just printed both parts, glued 2 neodymium-magnets (10 x 1,5mm round) in those holes and glued the handle and the lower part on my acrylic glass door.
Finally I drilled two holes (10mm round 1,5mm deep) in the casing at the high of the two handle parts and glued some neodymium-magnets in those holes too.
Check the polarity of the two magnets before glueing them in the casing.

No support needed.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

2 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen