Cults3D
Home
Zum Modell
Magnetic Frames 2
0
Downloads
0
Likes
0
Makes
aughter in law wanted magnetic frames for her refrigerator and this is what I came up with.
These are 2 pieces frames and will need to be glued each top and bottom. I used 3/8 inch magnetic tape from Amazon to be stuck on the back.
All frames are scalable up or down. Scale as you see fit. Just scale X and Y and leave Z alone for best results
Print Settings:
All Bottoms: 3 layers top and bottom 3 walls
Flower frame has alignment holes from the back. just use a couple drill nits to line them up for gluing
Infill at 15% for all pieces.
These are 2 pieces frames and will need to be glued each top and bottom. I used 3/8 inch magnetic tape from Amazon to be stuck on the back.
All frames are scalable up or down. Scale as you see fit. Just scale X and Y and leave Z alone for best results
Print Settings:
All Bottoms: 3 layers top and bottom 3 walls
Flower frame has alignment holes from the back. just use a couple drill nits to line them up for gluing
Infill at 15% for all pieces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
