MakerWorld
Decor
Go to Model
Magnetic fridge/map markers
2
Downloads
1
Likes
1
Makes
Read carefully before printing:This model designed to embed a single 4mm diameter x 1.5mm high circular magnet into the print by pausing mid print. You have to pause at a certain layer equal to 2.3mm high. Therefore I recommend setting your print settings so that layer height is 0.23mm rather than the default of 0.2mm, and setting a pause after printing layer 10. Once you insert all the magnets you can resume the print and the magnets would be encapsulated into the plastic. Then you can use this on a fridge or a map (like I've done) with another magnet on the other side.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!