Slicer Discord
Magnetic Gears – 3D-Druckmodell von Thingiverse Thingiverse
Magnetic Gears – Bild 1 Magnetic Gears – Bild 2 Magnetic Gears – Bild 3 Magnetic Gears – Bild 4
Learning

Magnetic Gears

43 Downloads
42 Likes
0 Makes
Zum Modell
Here is a simple magnetic gear demonstration. With the help of some cheap magnets (picture) and skateboard bearings, you too can make magnetic gears!

I used:
-0.4mm nozzle
-0.2 layer height
-100% infill
-no supports
You don't have to use these settings, but keep in mind that lower infill settings will cause it to be more flexible. This shouldn't be a problem if you use magnets as weak as the ones I used. The shafts have a snug fit and might require minimal sanding to slide the bearings on easier.
Kategorie
Learning
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
keine Supports · aufwändige Nachbearbeitung
Ohne Supports Einteilig Hardware nötig
Supports 0/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Schleifen, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen