Thingiverse
Magnetic glasses case
di brageeb
0
Download
1
Likes
0
Makes
In order to assemble the 4ea STLs you will need to:
1) Double check that your glasses fits the case width.
2) Print them all
3) Use 3ea 3mmX6mm magnets. The orientation of the two magnets on the upper half must be opposite to each other (one repulsing and one attracting the magnet in the lever). It's recommended to use a small amount of superglue for each magnet.
4) Use a segment of filament as hinge pin in order to connect the to halves.
1) Double check that your glasses fits the case width.
2) Print them all
3) Use 3ea 3mmX6mm magnets. The orientation of the two magnets on the upper half must be opposite to each other (one repulsing and one attracting the magnet in the lever). It's recommended to use a small amount of superglue for each magnet.
4) Use a segment of filament as hinge pin in order to connect the to halves.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
