Magnetic hex bit driver holder
door navvis
1
Downloads
0
Likes
0
Makes
Print standing right side up. No support needed.
This holds hex bits. It has room for 10mm x 3mm magnets in the back. Add a couple drops of super glue then press fit them into place.
The bit fit was calibrated with a 0.6mm nozzle so it might be a touch loose holding bits if printed with a 0.4mm nozzle. If desired, I could tinker out a version that works better for 0.4mm nozzles.
The wells are 1cm deep, so this is intended for full size bits (e.g. meant to be inserted and held in an impact driver on their own). So it may not be ideal for smaller bits. I'll consider making a shorter version for the simple stubby collar-less hex bits.
This holds hex bits. It has room for 10mm x 3mm magnets in the back. Add a couple drops of super glue then press fit them into place.
The bit fit was calibrated with a 0.6mm nozzle so it might be a touch loose holding bits if printed with a 0.4mm nozzle. If desired, I could tinker out a version that works better for 0.4mm nozzles.
The wells are 1cm deep, so this is intended for full size bits (e.g. meant to be inserted and held in an impact driver on their own). So it may not be ideal for smaller bits. I'll consider making a shorter version for the simple stubby collar-less hex bits.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
