Thingiverse
Magnetic Hose Bracket
von paulkoan
6
Downloads
2
Likes
0
Makes
This is a bracket that uses magnets for attachment. The inner diameter is 10mm.
The magnet diameter is 8mm, and I used 0.8mm depth ones so I can stack (up to three) them where it needs to be stronger.
The magnets go into the holes and a cap is friction fit to cover them.
This video shows assembly. Excuse the poor camera positioning for some of it :)
https://www.youtube.com/watch?v=PUCXOdhdL_A
The magnet diameter is 8mm, and I used 0.8mm depth ones so I can stack (up to three) them where it needs to be stronger.
The magnets go into the holes and a cap is friction fit to cover them.
This video shows assembly. Excuse the poor camera positioning for some of it :)
https://www.youtube.com/watch?v=PUCXOdhdL_A
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
![[Parametric] Angled Magsafe Clamp Holder](https://wsrv.nl/?url=https%3A%2F%2Fmakerworld.bblmw.com%2Fmakerworld%2Fmodel%2FUS2d70cbca90669a%2Fdesign%2F2025-08-05_043070ef2d57e.png&w=400&h=300)
