Thingiverse
Magnetic Knives Holder
von BieJay
2
Downloads
0
Likes
0
Makes
31cm wide Knive holder that fits 6 10x5mm neodyn magnets from behind.
I had to seperate the print into 2 parts because my anycubic i3 mega can't print parts that long.
Afterwards i glued the two parts together in the middle and taped it to my wall.
Printed with:
- 0.25mm layer height
- 15% infill
- holes facing downwards
- used support only on one part for the connection part
I had to seperate the print into 2 parts because my anycubic i3 mega can't print parts that long.
Afterwards i glued the two parts together in the middle and taped it to my wall.
Printed with:
- 0.25mm layer height
- 15% infill
- holes facing downwards
- used support only on one part for the connection part
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!