Thingiverse
Magnetic Light Switch Cover
by RevHazlett
1
Downloads
2
Likes
0
Makes
Just a little magnetic light switch cover. Fits US standard switches protruding up to 15mm out from the light switch plate face.
Designed to print smoothly and quickly (model is built on multiples of standard line widths of 0.42mm). Takes one 8x3mm magnet in each side, the holes are actually ∅8.2mm and 4mm deep.
Put a touch of CA glue on the bottom of the hole and press your magnets in (you can stack two to use one as a ram-rod) to leave a small recess so the screws in the light switch plate cover will fit inside them as they almost always poke out a little bit.
Designed to print smoothly and quickly (model is built on multiples of standard line widths of 0.42mm). Takes one 8x3mm magnet in each side, the holes are actually ∅8.2mm and 4mm deep.
Put a touch of CA glue on the bottom of the hole and press your magnets in (you can stack two to use one as a ram-rod) to leave a small recess so the screws in the light switch plate cover will fit inside them as they almost always poke out a little bit.
RevHazlett also publishes on
327 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
