Thingiverse
Magnetic Linear Encoder v1.1a
von ril3y
42
Downloads
37
Likes
0
Makes
This is a single Sided approach to this board. But the version 1.1V thats in the makerbot SVN.
I tested this board by hooking up an 5v arduino + GND then ran a magnetic strip over the IC. The activity light started blinking! So it looks like everything is working. This is also my first board I have laid out that was a double sided board converted to a single. Some places are "tight" but its doable. I have ohm'ed out all my connections and everything is great.
Video of it in action here:
http://www.flickr.com/photos/31697990@N00/4170462649/
Enjoy.
Ril3y
I tested this board by hooking up an 5v arduino + GND then ran a magnetic strip over the IC. The activity light started blinking! So it looks like everything is working. This is also my first board I have laid out that was a double sided board converted to a single. Some places are "tight" but its doable. I have ohm'ed out all my connections and everything is great.
Video of it in action here:
http://www.flickr.com/photos/31697990@N00/4170462649/
Enjoy.
Ril3y
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!