Slicer Discord
Magnetic Mount Eye Pro – 3D-Druckmodell von MakerWorld MakerWorld
Sport & Outdoors

Magnetic Mount Eye Pro

17 Downloads
18 Likes
10 Makes
Zum Modell
These are magnet mounted shooting glasses or eye protection meant to mount to the wire frame of your ear pro. It eliminates the annoyance and discomfort of wearing ears over the glasses and having to push them back under the ear if you take them off. You also get a better seal and consequently better hearing protection. I used 5x3mm magnets and my ears are Walker Razor Slims but it's possible this will work with any wire frame ear pro. The glasses are linked here:amazon.com/dp/B00JXLTO36?ref=ppx_yo2ov_dt_b_fed_asin_titleThey are only $10 glasses so you don't have to feel bad cutting the temples off. Just give yourself some extra stem length and slowly clip up it back until you get to the appropriate length. My guess is that you will need to clip it very close to the hinge. The mounts have a swing arm to help adjust to the placement of the magnets. I also set my glasses up over night spread out on the frame to help stretch them a bit wider.
Kategorie
Sport & Outdoors
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen