MakerWorld
Electronics
Zum Modell
Magnetic PCB Holder
25
Downloads
19
Likes
14
Makes
Magnetic PCB Holder for printer beds and extra plates. Snap it onto any steel print surface to securely hold your boards for soldering, probing, rework, and photos. The low-profile, adjustable clamps keep everything steady without getting in your way, and the magnetic base makes setup fast—no tape or messy putty.HighlightsFast magnetic hold on steel printer beds or spare metal platesAdjustable clamping to fit from small dev boards to larger PCBsLow profile for easy iron and probe accessSmooth, non-marring printed surfaces on board contact pointsHardwareM4 x 12 mm bolts and M4 nutsDisc magnets: your choice of 8 mm x 2 mm or 10 mm x 2 mm neodymiumPrinting and assembly tipsPrint in PETG or ABS for better heat resistance (PLA works if used on a cool surface)3–4 perimeters, 20–35% infill recommendedPress-fit magnets; add a drop of CA glue if looseMatch magnet polarity before installing so the base grips your plate
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
