Thingiverse
Electronics
Zum Modell
Magnetic PCB holder
134
Downloads
120
Likes
2
Makes
This is a spring loaded PCB holder.
Supports needed, only touching buildplate.
Parts used:
// 1 M3 x 12 Countersunk fastener
fastener = [ 3, 12], // diameter of countersunk fastener, length
// 1 Spring approximate diameter 11, length 20-30.
spring = [ 12, 9.8, 31, 10 ], // diameter_outer, diameter_inner, length, length compressed
// 1 Circular neodymium magnet diameter
Supports needed, only touching buildplate.
Parts used:
// 1 M3 x 12 Countersunk fastener
fastener = [ 3, 12], // diameter of countersunk fastener, length
// 1 Spring approximate diameter 11, length 20-30.
spring = [ 12, 9.8, 31, 10 ], // diameter_outer, diameter_inner, length, length compressed
// 1 Circular neodymium magnet diameter
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
