Slicer Discord
Magnetic plectrum holder – 3D-printbaar model van MakerWorld MakerWorld
Music

Magnetic plectrum holder

door Mark_McQ · Music
9 Downloads
13 Likes
1 Makes
Model downloaden
This is a magnetic pick holder designed to stick to the front of any amp with a metal faceplate. It holds 7 picks. Multiple STL files are included with slots going from 0.6mm up to 1.2mm. A sizing gauge is also included which can be printed to help determine the best slot size to use for your picks. It starts at 0.6mm on the side with the 2 protruding chamfers, up to 1.2mm on the flat side. The slots go up by 0.05mm. Both the gauge and the holders should be printed on their sides with the slots aligned vertically. 2 x 10mm round magnets are required, 3mm thick.
Categorie
Music
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Mark_McQ publiceert ook op

43 extra modellen op 3 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie