Thingiverse
Magnetic Pushpin (10mm)
by rlaska
22
Downloads
8
Likes
0
Makes
QUICK DESCRIPTION: Don't bother with the first three files, because they turn out incredibly fragile. They're just there to document my learning process. Print v3 if you have an older printer which struggles with overhangs, or v4 if you have a newer printer and are feeling a little more adventurous. NEW: v5 goes back to the v3 style, but has the flat surface of v4 to make attaching the magnet easier (cylindrical cavity for the magnet, rather than a conic cavity)
----
These are 16 magnetic push-pins I made for the 10x3mm magnets I got bulk from Amazon. Should print fine without supports, not sure about the need for a raft. Build surface required is only 66x66x20mm, so you can duplicate the object if you want multiples of 16 to be printed at once, or pare them down if you want fewer. I also made them 6mm apart, but this may not be the best choice. I wasn't sure how far apart they needed to be for best printing (less stringing). Good luck!
The reason for the odd and primitive (wi
----
These are 16 magnetic push-pins I made for the 10x3mm magnets I got bulk from Amazon. Should print fine without supports, not sure about the need for a raft. Build surface required is only 66x66x20mm, so you can duplicate the object if you want multiples of 16 to be printed at once, or pare them down if you want fewer. I also made them 6mm apart, but this may not be the best choice. I wasn't sure how far apart they needed to be for best printing (less stringing). Good luck!
The reason for the odd and primitive (wi
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
