MakerWorld
Jewelry
Zum Modell
Magnetic ring case
98
Downloads
72
Likes
74
Makes
Ring case using two circular 10x4mm or four 10x2mm magnets. After printing, stick the magnets, for example, using epoxy glue. The inner space for the ring has an inner diameter of 13mm, an outer diameter of 25mm.The second print profile uses 5x2mm magnets. Printer will pause for you to insert magnet. Remember to flip polarity on the second magnet you insert. No glue needed since the printer will seal it in. Also increased the depth so it will hold a men's 6mm wide ring. Thank @smoke.007 for this print profile.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
