Magnetic Screw Tray

Screw tray for 8x3mm neodymium magnets.

Magnets can be pushed in place after printing, and stay put nicely. They can also be removed if needed. The dimensions of the tray are 80 x 40 x 12 mm

- To install magnets: Push the magnet into the wider slots using a screwdriver until they snap into place.
- To remove magnets: Push a small hex wrench or similar into the smaller hole on the opposite side of the tray to dislodge the magnets.

Suitable magnets can be found here: https://www.aliexpress.com/wholesale?catId=0&origin=y&SearchText=neodymium+magnet+8x3mm

or here: https://www.amazon.com/s?k=neodymium+magnets+8x3mm

NOTE: The same magnets can be used for the extruder indicator on Prusa printers. Check out the "Extruder rotation vizualizer" by mikolaszuza: https://www.thingiverse.com/thing:2759852